[. . . ] 22
Safety & Regulatory Information
iii
1
Agency Notices
Regulatory Compliance Identification Numbers
For the purpose of regulatory compliance certifications and identification, your product has been assigned a unique Compaq series number. The series number can be found on the product nameplate label, along with all required approval markings and information. When requesting compliance information for this product, always refer to this series number. The series number should not be confused with the marketing name or model number of the product.
Federal Communications Commission Notice
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
I I I I
Reorient or relocate the receiving antenna. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio or television technician for help.
11
Safety & Regulatory Information
Agency Notices
Modifications
The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved by Compaq Computer Corporation may void the user's authority to operate the equipment.
Mouse Compliance Statement
This device complies with Part 15 of the FCC Rules. This device must accept any interference received, including interference that may cause undesired operation.
Cables
Connections to this device must be made with shielded cables with metallic RFI/EMI connector hoods in order to maintain compliance with FCC Rules and Regulations.
12
Safety & Regulatory Information
Agency Notices
Declaration of Conformity for Products Marked with the FCC Logo (United States only)
This device complies with Part 15 of the FCC Rules. This device must accept any interference received, including interference that may cause undesired operation. For questions regarding your product, contact: Compaq Computer Corporation P. With specific regard to the laser, the equipment complies with laser product performance standards set by government agencies as a Class 1 laser product. The product does not emit hazardous light; the beam is totally enclosed during all modes of customer operation and maintenance.
ÅI
WARNING: To reduce the risk of exposure to hazardous radiation: Do not try to open the laser device enclosure. I Do not operate controls, make adjustments, or perform procedures to the laser device other than those specified herein. I Allow only authorized Compaq service providers to repair the laser device.
CDRH Regulations
The Center for Devices and Radiological Health (CDRH) of the U. S. Food and Drug Administration implemented regulations for laser products on August 2, 1976. These regulations apply to laser products manufactured from August 1, 1976. Compliance is mandatory for products marketed in the United States.
Compliance with International Regulations
All Compaq systems equipped with CD-ROM drives comply with appropriate safety standards including IEC 825.
16
Safety & Regulatory Information
Agency Notices
Laser Product Label
The following label or equivalent is located on the surface of Compaq laser products:
This label indicates that the product is classified as a CLASS 1 LASER PRODUCT. This label appears on a laser device installed in your product.
If you have an LS-120 drive or an LS-260 drive, this label is located next to the Class 1 Laser Product label on your system.
Laser Information
I I I I I I
Laser Type: Wave Length: Divergence Angle: Output Power: Polarization:
Semiconductor GaAIAs 780 +/- 35 nm 53. 5 Degrees +/- 0. 5 degrees Less than 0. 2 mW or 10, 869 W·m-2 sr-1 Circular 0. 25
Numerical Aperture: 0. 45 inches +/- 0. 04 inches
Safety & Regulatory Information
17
Agency Notices
Battery Replacement Notice
Å
WARNING: Your computer contains an internal lithium manganese dioxide, vanadium pentoxide, or alkaline battery or battery pack. There is risk of fire and burns if the battery pack is not handled properly. [. . . ] This label appears on a laser device installed in your product.
If you have an LS-120 drive or an LS-260 drive, this label is located next to the Class 1 Laser Product label on your system.
Laser Information
I I I I I I
Laser Type: Wave Length: Divergence Angle: Output Power: Polarization:
Semiconductor GaAIAs 780 +/- 35 nm 53. 5 Degrees +/- 0. 5 degrees Less than 0. 2 mW or 10, 869 W·m-2 sr-1 Circular 0. 25
Numerical Aperture: 0. 45 inches +/- 0. 04 inches
Safety & Regulatory Information
17
Agency Notices
Battery Replacement Notice
Å
WARNING: Your computer contains an internal lithium manganese dioxide, vanadium pentoxide, or alkaline battery or battery pack. There is risk of fire and burns if the battery pack is not handled properly. To reduce the risk of personal injury: I Do not attempt to recharge the battery. I Do not disassemble, crush, puncture, short external contacts, or dispose of in fire or water. [. . . ]